Hp Netserver Lm System Updates; Factory Installed Scsi Hard Drive - HP LC2000r - NetServer - 128 MB RAM Handbook

To take advantage of the upgrade, you must also install the appropriate drivers. Consult the HP PC bulletin
board for a list of the required drivers. Hewlett-Packard does not supply or support the drivers.
CAUTION
When you reboot the server, the system BIOS shows the video memory size during the Power-On Self-Test
(POST) to verify that the additional video memory DRAM is installed correctly. If the video display does not
work when you power up the server, remove the upgrade video DRAMs and check the chips for bent pins.

HP NetServer LM System Updates

These notes reflect changes for the HP NetServer LM which could not be included with the service manual
or were changed at a later date. Service manuals are not updated and the information, if any, in this section
is the latest information available. See also the HP NetServer LM Update, HP Part No. D2332-90009, for
additional information on operating systems.

Factory Installed SCSI Hard Drive

Some LM models have a factory installed SCSI hard disk drive. The SCSI hard disk drive has a set of mode
select switches located on the rear of the drive. Switches 1, 2, and 3 are not customer adjustable, and
factory settings should not be changed. The SCSI hard disk drive comes with the SCSI address set for ID 0.
SCSI Hard Disk Drive ID Jumper Settings
ID 0
ID 1
ID 2
ID 3
ID 4
ID 5
Intel
Toshiba
Texas
Instruments
Apply gentle pressure on the pins. They can bend easily. If a pin does not align with
a hole, carefully use needle-nose pliers to straighten the pin.
Jumper 6 Jumper 5
Jumper
Jumper
Jumper
Jumper
P21014-06
TC514256Ap-60
TMS44C256N-60
6 5 4
3 2 1
SCSI ID
Jumper 4
Jumper
Jumper
Jumper
125