Hp Netserver Lh Memory Configuration; Hp Netserver Lh Plus/Pro Memory Configuration; Lh Plus/Pro Processor Board Led Blink Codes - HP LC2000r - NetServer - 128 MB RAM Handbook

Switch
IO CTRL ENABLE: Enables or disables onboard flexible disk drive
7
controller, IDE controller, and serial and parallel ports.
ON: I/O controller enabled.
OFF: I/O controller disabled.
8 VIDEO ENABLE: Enables or disables built-in video. Disable the built-in
video only if you have a separate video board installed in the server.
ON: Enables built-in video.
OFF: Disables built-in video.

HP NetServer LH Memory Configuration

The following HP SIMMs are supported:
Type
8 MB ECC SIMM
16 MB ECC SIMM
32 MB ECC SIMM
SIMMs must be installed in pairs.
SIMMs must be installed in sequential order starting with Banks 0/1.

HP NetServer LH Plus/Pro Memory Configuration

The processor board has 4 memory sockets which accept DIMM memory modules. Up to 512 MB of memory
can be added. When installing additional memory, note the following:
Only these HP DIMMs are supported:
DIMM Type
16 MB DIMM
32 MB DIMM
64 MB DIMM
128 MB DIMM
256 MB DIMM
Any combination of DIMMs, listed above, may be used.
NOTE

LH Plus/Pro Processor Board LED Blink Codes

The Processor board in the NetServer LH Plus or Pro contains LEDs that can indicate memory errors and
processor errors. When a memory error exists, the LEDs are either on, off, or flash repeatedly a constant
memory error code. The table below describes each of these codes. If the memory error indicates a failed
DIMM, replace the DIMM. When a processor error exists, the LEDs alternate between two codes (i.e., ON-
OFF-OFF-OFF and OFF-ON-ON-ON).
84
Product Number
D3597A
D3592A
D3593A
HP Product
Number
D4294A
D4295A
D4296A
D4297A
D4926A
The HP warranty does not cover performance problems, equipment problems, or
service calls resulting from the use of non-HP DIMMs.
Function Default
ON
ON