Rear Panel Controls, Ports, And Indicators - HP LC2000r - NetServer - 128 MB RAM Handbook

Hp netserver service handbook, volume 2 - mid
Hide thumbs Also See for LC2000r - NetServer - 128 MB RAM:
Table of Contents

Advertisement

Drive Active LED
Drive Error LED
Over-Temperature LED
Fan Failure LED

Rear Panel Controls, Ports, and Indicators

Power Inlet
Ultra SCSI
Indicator
Link LED
Activity LED
100 mbps LED
130
LED goes on (green) to indicate access over the LPr's embedded SCSI bus.
This includes access to both internal and external drives.
LED flashes red to indicate that one of the two drives in the hot-swap bays
has failed and must be replaced.
LED flashes yellow to indicate that one of the two drives is predicted to fail
and should be replaced. You may have time to back up the drive before
replacing it.
: You may have to remove the front bezel to see the specific drive LEDs
NOTE
and determine which device is in trouble.
LED flashes red when any one of several temperature sensors within the LPr
indicates damage to the system is imminent. Power down the system
immediately.
LED flashes yellow to indicate internal temperature is nearing damaging
levels. Perform a graceful shutdown and power down the system.
LED flashes red to indicate a fan failure. Power down the system
immediately.
LED flashes yellow to indicate a fan is a lower than normal speed. Unless the
over -temperature indicator is flashing red or yellow, you may perform a
graceful shutdown and then power down the system and correct the fan
problem.
This indicator reports on the power supply fan as well as the three fans in the
internal LPr fan pack.
PCI slot 3
PCI slot 2
PCI slot 1
Keyboard
Monitor
This LED goes on to indicate that both the network adapter in the LPr and the
network switch are receiving power and that they are properly connected.
This LED flashes to indicate data transfers to/from the LPr network adapter. The
rate of flashes varies directly with network traffic.
This LED goes on to indicate that the LPr network adapter is supporting transfers
at the 100 mbps (million bits per second) rate. When off, the LPR is working at 20
mbps.
Network (PCI slot 4)
Link LED
Activitity LED
100 mbps LED
Management Port
Mouse
Parallel
Port
Definition
Serial
Port B
Serial
Port A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents