Mounting The Water Valve - Whirlpool ECKMF94 - Automatic Ice Maker Installation Manual

Mounting the water valve
Refer to the diagram below for the following
steps.
1. Locate the 2-pin water valve solenoid
3. Refer to DETAIL B and mount the water
connector (with the brown and two white
valve to the mounting holes in the cabinet
wires) that is taped to the main wiring
frame with two X'hex-head machine
harness at the lower right corner of the rear
screws. Make sure that you tighten these
access (see DETAIL A). two screws securely.
2. Refer to DETAIL B and insert the 2-pin
connector over the water valve solenoid
terminals as far as possible (if the harness
is not long enough, break the tape holding it
to the main harness). You can position the
connector with the wires at either terminal.
Mounting the water valve
/
DETAIL A -\
f
/
DETAIL B
H' hex-head
machine screwa