Whirlpool ECKMF94 - Automatic Ice Maker Installation Manual page 15

Refer to the side diagrams for the following
steps.
1. Position the ice maker inside the freezer
compartment and connect its wiring con-
nector to the wiring harness connector so
they lock together (the locking arm will snap
over the raised tab). The connectors will fit
together only one way.
2. For Top/Bottom Freezers Only:
Hang the
ice maker over the two hex-head screws
you installed earlier. Make sure that the
bottom mounting bracket hole is aligned
with the mounting hole in the freezer liner,
then tighten the two top hex head screws.
Be careful not to over-tighten the screws.
3. For Side-By-Side Models Only:
Position the
ice maker so that its top and bottom mount-
ing tabs are flat against the side of the
freezer liner. Center the top tabs under the
two mounting clips, and push the ice maker
straight up so that the mounting clips snap
over the tabs and lock into place (you
should hear them 'click" as they lock).
4. Mount the bottom bracket of the ice maker
to the freezer liner mounting hole with a %"
hex-head sheet-metal screw.
screw
Mounting the ice maker
(top and bottom freezers)
bracket
connectors
Mounting the ice maker
(sideby-side models)
15