Whirlpool ECKMF94 - Automatic Ice Maker Installation Manual page 8

Refer to the side diagram for the following
step. You will be working inside the freezer
compartment.
1. Position the long aluminum fill tube exten-
sion so that the curve is pointing down, and
slide the flared end over the fill tube as far
as it will go (see DETAIL A). Some kits may
have a long straight plastic extension in
place of the long bent aluminum extension.
Install the plastic extension by sliding it over
the fill tube as far as it will go.
Refer back to the side diagram for the
following step.
2. Position the wiring harness so that it is
through the slot in the wiring cover. Insert
the tab at the back of the wiring cover into
the freezer liner slot. Press the pin on the
side of the wiring cover into the hole in the
side of the freezer liner so it locks into
place. Secure the wiring cover with the
phillips screw you removed earlier.
Proceed to "Installing the tubing clips" on
page 10.
w
tiring hard
@
- %&s-
-I -5
AL
pointing down
Long fill
tube extension
A
w-
I
Installing the long fill tube extension
an pm
Ihole
qliole cover
HOI
0
Wring
harnesa
c)
0
Wiring
cover
Replacing the ke maker wiring cover
8