Table of Contents
Advertisement
Before You Begin
Tools
You will need these tools to install your kit.
1. Regular screwdriver
2. Phillips screwdriver
3.
%6"
and l/i' open-end wrenches (or an
adjustable wrench)
4. Pliers
5.%* nut driver
6. Hand drill with 1/4* drill bit
7. Small hand level (optional)
8. Small %-round file
9. Tubing cutter
10. Center punch
11. Hammer
12. Scissors
13.Ruler
14. Step stool (optional)
Installation
notes
1. Follow the instructions carefully. Read
through the entire step so that you under-
stand it before you perform it.
2.The illustrations in this Installation Guide
are meant to clarify the installation steps
you need to perform. For each set of steps
shown, refer to the diagram immediately
beside or below the text for clarification.
Some illustrations also contain 'DETAILS."
DETAILS are contained in bubbles along-
side the larger illustration. A DETAIL shows
a close-up illustration of a certain portion of
a diagram or an illustration of a specific step
you are to perform. DETAILS are labeled A,
B, or C and are clearly referenced in each
step.
3. When you are instructed to install a part,
position the part as shown in the illustration.
Important
safety
instructions
Electrical Shock Hazard
If you intend to use power tools, such as
an electric drill, during the installation,
make sure that the AC receptacle is
properly grounded in accordance with the
National Electrical Code (ANSVNFPA 70)
and all local codes and ordinances. The
tools must have a 3-prong grounding plug
(see illustration) to minimize the danger
of electrical shock. If a mating receptacle
is not available, it is the personal respon-
sibility of the customer to have a properly
grounded 3-prong wall receptacle and
plug installed by a qualified electrician.
Failure to follow this instruction could
result in death or personal injury.
3-prong
grounding-
8prong
type wall
grounding
receptacle
plug \
Correct power receptacle and plug configuration
A
Hide quick links:
Advertisement
Table of Contents
