Plugging In The Power Cord - Dell DAE2-ATA Hardware Reference Manual

Servicing a DAE2
Figure 3-18
3-22 2-Gigabit Disk-Array Enclosure (DAE2) Hardware Reference
4. Turn the latch clockwise to secure the module.
The latch holds the power/cooling module in an established position. It
does not pull or otherwise help to seat the module.
5. Make sure any power switch on the replacement module is off
before you plug the ac power cord into the new supply as shown
in Figure 3-18. Turn a power switch to the on position after you
plug in the ac power cord.
ac
Connector

Plugging in the Power Cord

Make certain you secure the power cord with the retention bails at each
connector. The bails prevent the power cord from pulling out of the
connections.
Retention
Bail
EMC2778