Service Mode-3,000-Sheet Stapler/Stacker And 3,000-Sheet Stacker; Figure 183. 3,000-Sheet Stapler/Stacker And 3,000-Sheet Stacker Diagnostics Label - HP Color LaserJet 9500 Service Manual

Service mode—3,000-sheet stapler/stacker and 3,000-sheet
stacker
Service-mode configuration
Perform the following steps to put the device into service mode.
CAUTION Make sure that the printer or MFP is turned off before performing this test. If the printer or MFP is
on when service mode is enabled, damage to the output device, the printer, or the MFP could occur.
1
2
Note When the device has entered service mode, it performs a short self-test. The green error light
blinks if no jams or malfunctions were detected.
To exit service mode
1
2
Note Press the interlock switch during the test to perform a reset and to restart the test.
Service-mode diagnostics
Diagnostics labels are attached to the PCB covers of the 3,000-sheet stapler/stacker and the
3,000-sheet stacker.
Figure 183. 3,000-sheet stapler/stacker and 3,000-sheet stacker diagnostics label
ENWW
Remove the controller PCB cover.
Slide the service mode switch on the controller PCB to the on position (toward you).
Slide the service mode switch on the controller PCB to the normal position.
Reinstall the controller PCB.
Chapter 7 Troubleshooting 239