Dell PowerEdge M620 Owner's Manual page 131

Table 1-27. Blade Messages
Message
The amount of
system memory has
changed.
This system does
not support
processors greater
than 95W.
Time-of-day clock
stopped.
Time-of-day not
set — please run
SETUP program.
Timer chip counter
2 failed.
TPM failure
(continued)
Causes
Faulty memory module.
Unsupported processor(s)
installed.
Faulty battery; faulty blade
board.
Incorrect Time or Date
settings; faulty blade board
battery.
Faulty blade board.
A Trusted Platform
Module (TPM) function
has failed.
Corrective Actions
See "Troubleshooting Blade
Memory" on page 319. If the
problem persists, see
"Getting Help" on page 361.
Replace the processor(s)
with a supported version.
See "Processors" on
page 243.
See "Troubleshooting Blade
Memory" on page 319. If the
problem persists, see
"Getting Help" on page 361.
Check the Time and Date
settings. See "Using the
System Setup Program
and UEFI Boot Manager" on
page 137. If the problem
persists, see
"Troubleshooting the
NVRAM Backup Battery" on
page 324.
See "Getting Help" on
page 361.
See "Getting Help" on
page 361.
About Your System
131