Installing The System Board - Dell PowerEdge M620 Owner's Manual

11 Remove the video riser card or daughter card. See "Video Controller
(PowerEdge M905, M805, M605, and M600 Only)" on page 272.
12 Remove the memory modules and memory module blanks. See "Removing
Memory Modules" on page 214.
13 Remove the processor(s). See "Removing a Processor" on page 244.
14 Remove the storage controller board. See "Removing the Storage
Controller Board" on page 281.
15 Remove the NIC hardware activation key. See "System Board Connectors"
on page 338 for the location of the key.

Installing the System Board

1 Transfer the following components to the new system board:
• NIC hardware activation key. See "System Board Connectors" on
page 338 for the location of the key.
• Internal USB key.
• Storage controller board. See "Installing the Storage Controller Board"
on page 282.
• SD vFlash card (PowerEdge M910, M710, and M610 only). See "SD
vFlash Card (PowerEdge M915, M910, M710, M710HD, M610, and
M610x Only)" on page 225.
• SD card. See "SD Card" on page 223.
• Memory modules and memory module blanks. See "Installing
Memory Modules" on page 213.
• Processor(s) and heat sink(s), or processor filler blank. See "Installing a
Processor" on page 259.
• HT bridge cards (PowerEdge M905 only). See "HT Bridge Card
(PowerEdge M905 Only)" on page 262.
• FlexMem bridges (PowerEdge M910 only). See "FlexMem Bridge
(PowerEdge M910 Only)" on page 261.
280
Installing Blade Components