4 Lift the card from the system board.
5 Close the blade. See "Closing the Blade" on page 161.
6 Install the blade. See "Installing a Blade" on page 158.
Figure 3-35. Removing or Installing the Integrated Network Card
1
screw (3)
3
LOM riser card connector
Installing the LOM Riser Card
1 Remove the blade. See "Removing a Blade" on page 155.
2 Open the blade. See "Opening the Blade" on page 159.
3 Install the Network Daughter Card:
Lower the card into place until the card connector fits into the
a
corresponding connector on the system board. See Figure 3-35.
Secure the card with the three screws.
b
234
Installing Blade Components
1
2
LOM riser card
2
3