Reset The System - Dell PowerEdge M620 Owner's Manual

Table 1-27. Blade Messages
Message
TPM configuration
operation is
pending.
Press (I) to
Ignore OR (M) to
Modify to allow
this change and

reset the system.

WARNING: Modifying
could prevent
security
TPM configuration
operation honored.
System will now
reset
Unsupported CPU
combination.
Unsupported CPU
stepping detected.
CPU set to minimum
frequency.
132
About Your System
(continued)
Causes
This message is displayed
when the system re-starts
after a TPM configuration
command is entered.
TPM configuration
operation command has
been accepted
Mismatched processors are
installed.
Processor is not supported
by the blade.
Processor is not supported
by the blade.
The processor speed may
be intentionally set low for
power conservation.
Corrective Actions
Enter I or M to proceed.
For information only.
Replace a processor so that
both processors match. See
"Processors" on page 243.
Check for a BIOS update
using the Dell Support
website at support.dell.com.
Check for a BIOS update
using the Dell Support
website at support.dell.com.
If the problem persists,
install a supported processor.
See "Processors" on
page 243.
If not an intentional setting,
check any other system
messages for possible causes.