Fujitsu ETERNUS VSS Hardware Provider 2.1 User Manual page 120

Chapter 9 Messages
9.2 Command Messages
■
STXV0902 ERROR Failed to access device. Error code = "internal error
code","detailed error code"
[Meaning]
Failed to access a device.
[Action]
Deal with the error according to the contents of the ETERNUS Disk storage systems "detailed error
code", and try again.
For more details about the "detailed error code", refer to
The Target Disk Pool Registration/Deletion function may have been started while backup was being
performed to the disks with physical disk numbers followed by the error message STXV0902 displayed
in the Target Disk Pool Registration/Deletion window. Click the [CANCEL] button to close the window,
check that no backup operations from the requester are in progress, and try again.
■
STXV0903 WARNING the back-up disk Pool control file was updated. These
changes will be discarded.
[Meaning]
Because the target disk pool management file was updated, the changes to the target disk pool man-
agement file were not applied.
[Action]
The backup process is performed and the target disk pool management file is updated when the Target
Disk Pool Registration/Deletion window is displayed or the Target Disk Pool Registration/Deletion Com-
mand is performed. Reply to the message and try again.
■
STXV3001 ERROR Invalid number of parameters.
[Meaning]
The number of parameters specified is invalid. The process is canceled.
[Action]
Correct the parameter, and try again.
■ STXV3002 ERROR Invalid parameter. Parameter = "Parameter"
[Meaning]
The specified "Parameter" is invalid. The process is canceled.
[Action]
Correct the parameter, and try again.
120
ETERNUS VSS Hardware Provider 2.1 User's Guide
Copyright 2012 FUJITSU LIMITED
"9.3 Detailed Error Codes" (page 125).
P3AM-4582-03ENZ0