Table of Contents
Advertisement
Prelminary
2004.11.12
CONNECTED SPECIFICATION OF MB91401 AND ICE
Recommended type and circuit configuration of the emulator interface connector mounting on the user system,
attention when designing and wiring regulation are shown.
When the flat cable is used, the combination of the connectors with housing should be selected.
Recommended connector type
Attached cable
FPC cable
FH10A-30S-1SH (Maker : Hirose Electric Co., Ltd.) With latch
Circuit composition
Please put the dumping resistance 15
operation when connecting it with ICE. Resistance must be mounted near the terminal ICLK of this LSI when
you design the printed wiring board.
Emulator interface connector
MB2198-0 and MB2197-01 side
ICS2 to ICS0
ICD3 to ICD0
BREAKI
xRSTIN
*1 : Use the line (inter connect) to flow the rating current or more.
*2 : The change circuit might become necessary, and refer to "Precaution when designing".
*3 : Mount resistance near the terminal ICLK of MB91401.
Part number
in the series in the ICLK terminal signal because of the stability of
UV
CC
FUSE
ICLK
RST
(Open)
Reset output
FR
circuit
GND
V
SS
MCU for evaluation
MB91401
V
CC
1
V
CC
3
15
ICLK
ICS2 to ICS0
ICD3 to ICD0
BREAKI
INITXI
10 k
2
MB91401
Remarks
21
Advertisement
Table of Contents
