Setting The Hard Disk Drive Jumpers - Epson 3865X Plus User Manual

Setting the Hard Disk Drive Jumpers

You need to check or change the hard disk drive jumper settings
if you are doing either of the following:
system.
If you are removing your only hard disk drive, you do not need
to set any jumpers. See "Removing a Hard Disk From the
Vertical Position," on page B-24, for instructions.
Before you install any hard disk drive in your computer, you
need to check or change the jumper settings on the drive(s).
The jumpers tell the computer whether you are using one hard
disk drive or two.
If you remove one hard disk drive and leave another in your
computer, you need to change the jumper settings on the
remaining drive to indicate that you now have only one hard
disk drive installed.
The following table lists the jumper settings for all the possible
hard disk drive configurations.
Jumper
positions
HSP
C/D
DSP
ACT
X = jumper installed
- = no jumper installed
Installing and Removing Disk Drives
B-4
Drive configurations
One hard
disk drive
-
X
-
X
Two hard disk
drives: master
-
X
X
X
Two hard disk
drives: slave
-
-
-
X