Moving the Cursor Block
Use
through the options on the main Setup menu. After you
highlight the option you want, press
you need to enter numbers while
and you want to use the numereric
turn it back on.
Follow the instructions in the rest of this chapter to use the
Setup program to define your computer's configuration.
Setting the Display Adapter Type
The Setup program can usually detect the exact type of display
adapter you are using with your computer. If you have
connected a VGA monitor to the built-in VGA port, the Setup
program automatically sets this value
type. (With this option you select the type of display adapter
you are using-not the type of monitor). If you have installed a
display adapter card-or you just want
adapter setting-follow these steps.
N
o
you have installed a display adapter card that
If
or an EGA card, you must set jumper J6 an the main system
board to disable the built-in VGA interface so
can operate as the primary display adapter. See Chapter 4 for
instructions on changing jumper settings.
2-6
Running the Setup
t
e
.
Program
Enter
to select it.
for
the display adapter
to
check the display
is
that
not a VGA
your card