Setting The Clock (Remote Control Only) - Sharp AN-PR1500H Operation Manual

Setting the clock (Remote Control only)

AN-PR1500H
In this example, the clock is set for the 24-hour (0:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the
and press the MEMORY/DIMMER button.
4
Press the or
then press the MEMORY/DIMMER button.
"0:00"
"AM 12:00"
"AM 0:00"
28
1 2 3
4 5 6
7 8 9
0 +10
or button to select "CLOCK",
button to select 24-hour or 12-hour display and
The 24-hour display will appear.
(0:00 - 23:59)
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
5
Press the or button to adjust the hour and then press the
MEMORY/DIMMER button.
Press the or button once to advance the time by 1 hour. Hold it down to
advance continuously.
6
Press the or button to adjust the minutes and then press the
MEMORY/DIMMER button.
Press the or button once to advance the time by 1 minute. Hold it down
to change the time in 5-minute intervals.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button.
The time display will appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the or
The time display will appear for about 10 seconds.
Note:
The "CLOCK" will appear or time will flash to confirm the time display when the AC
power supply is restored after a power failure or unplugging the unit. If incorrect,
readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" does not appear in step 3,
step 4 (for selecting the 24-hour or 12-hour display) will be skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Factory reset, clearing all memory"
on page 62 for details.]
2 Perform "Setting the clock" from step 1.
button to display the time.