Printing A Test Page From Your Computer; Windows 95, Windows 98 Or Windows Nt 4.0; Windows 3.1X - Sharp AR-PB2 Operation Manual

Digital copier printer expansion kit

Hide thumbs Also See for AR-PB2:

Table of Contents

PRINTING FROM A COMPUTER

1. Ensure that the printer cable is connected between your computer and the printer and then turn on

your computer.

2. Insert the printer driver diskette for the PPD driver for Windows 95/Windows 98 into the floppy disk

drive.

3. On the Windows 95/Windows 98 Start menu, select 'Run'.

4. Type A:\PFMSETUP (if the floppy disk drive is designated as drive A) and click the 'OK' button.

5. Follow the instructions on your screen to install the resident font information.

6. When the installation is complete, restart Windows.

Printing a Test Page from Your Computer

This section describes how to print a test page from your computer. Printing a test page verifies

that the printer and your computer are connected correctly.

NOTE

Users of Windows 95, Windows 98 or Windows NT 4.0 will be prompted to print a test page when installing their

selected printer driver(s). Otherwise, follow the procedures given below.

1. If necessary, install the appropriate printer driver(s). Refer to 'Installing Printer Drivers' for specific

instructions.

2. From the Windows desktop, click on 'Start.'

3. Highlight 'Settings' and then click on 'Printers.'

4. Right click on the Sharp printer icon and then click on 'Properties.'

5. Click on 'Print Test Page.'

6. Follow the instructions on the screen to finish printing the test page.

1. If necessary, install the appropriate printer driver(s). Refer to 'Installing Printer Drivers' for specific

instructions.

2. Print a test page or test document using one of your installed word processing programs such as

Notepad.

Refer to Chapter 4 on Operation Panel to make sure the printer is ready and on-line to print the document.

NOTE

Table of Contents