Selecting The Online Mode; Tray Select And Job Cancel; Tray Selection - Sharp AR-PB2 Operation Manual

USING THE OPERATION PANEL
When the printer mode is in effect and a document is being printed, pressing the COPY key will
change the setting to the copier mode but will not interrupt the current print job until the START key
is pressed. When the copying job is complete, the print job will resume automatically but the copier
mode will remain in effect.
NOTE If copying is performed, the print job will resume when no copier operation is performed for a programmed period of
time. To resume printing immediately after copying is complete, press the PRINT key.

Selecting the Online Mode

If the printer is in the offline mode, printing cannot be performed. To select the online mode, use
the procedure below.
1. If the printer is in the copier mode, press the PRINT key to select the printer mode.
The basic screen of the printer mode will appear.
2. Press the "ONLINE/OFFLINE" key on the touch panel to switch the printer to the online mode.
3. Press the COPY key to select the copier mode.

Tray Select and Job Cancel

Tray Selection

The "PAPER SELECT" key on the touch panel can be used to change paper trays when printing
has stopped for one of the following reasons.
In 'Auto Select' paper source selection mode, all trays on the printer configured for the
requested paper size are out of paper or no trays on the printer are configured for the
requested paper size.
If a paper source has been specified, the requested tray on the printer has run out of paper.
If there are no paper trays in the printer configured with the paper size requested, the printer
will request that paper be loaded on the bypass tray.
In most cases it will be best to load or re-load the printer with the appropriate paper size and
continue printing. If it is preferable to continue printing from a different tray (possibly containing a
different size paper than requested by the computer), follow the procedure below.
34