Introduction; Mounter Parts; Spectroproofer Mounter 17 - Epson SpectroProofer Mounter 17 User Manual

SpectroProofer Mounter 17"

Introduction

Mounter Parts

SpectroProofer Mounter 17"
Front
A
Handles
Use the handles when installing or removing the
SpectroProofer Mounter 17".
B
Front Cover
Open the cover when installing or removing
ILS20EP/ILS20EPUV, connecting cables, or
performing maintenance.
Caution:
c
Except for in the situations mentioned above, do
not open the cover. Otherwise, the device may not
work correctly.
C
Paper Presser
Holds the paper during measuring color.
D
ILS DC cable
Supplies power to ILS20EP/ILS20EPUV.
E
ILS communication cable
Receives data from ILS20EP/ILS20EPUV.
User's Guide
Introduction
5
F
Color Measurement Device carriage
Install ILS20EP/ILS20EPUV here.
Rear
A
Air vent
Takes in air to dry the color measurement chart
printed by the printer.
Do not block or clog the air vent. Otherwise, air
cannot be taken in and prints will not be dried
sufficiently. Clean the vent if it is dusty.
B
Side Cover
Open the cover when connecting or removing the
printer connection cable.
C
Printer connection cable
Connect the mounter to your printer with this cable.
D
Power connector(base)
Supplies power to the mounter from the printer.
E
White calibration tile holder insert slot
Insert the white calibration tile holder here.
F
Backing insert slot
Insert white or black backing here.