Color Measurement Device(Ils20Ep/ Ils20Epuv) - Epson SpectroProofer Mounter 17 User Manual

SpectroProofer Mounter 17"
Accessories
A
Backing
Backing are plates placed underneath the paper
during color-measurement. Attach either black or
white backing to the mounter.
Note:
Choose the white or the black backing depending on your
needs.
If you have used a color measurement device previously,
refer to its specification.
B
White calibration tile holder
Holds the white calibration tile.
C
Paper guide unit for SpectroProofer Mounter
Install this guide when using the mounter to correct
the paper path.
Color Measurement Device
(ILS20EP/ILS20EPUV)
Note:
The Color Measurement Device may be sold separately.
In this case, you need to purchase ILS20EP or
ILS20EPUV depending on your needs.
A
Lens
Scans the print when measuring colors.
User's Guide
Introduction
6
B
DC connector
Attach the DC connector to the ILS DC cable located
on the Color Measurement Device carriage, placed
at the front of the mounter.
C
Communication connecter
Attach this connecter to the ILS communication
cable located on the color measurement device
carriage on the base of the mounter.
D
White calibration tile
The white-based tile for color measurement data.
Use this tile by attaching the white calibration tile
holder.
Caution:
c
Use ILS20EP/ILS20EPUV and the white
calibration tile contained in the set that comes with
this product.
ILS20EP/ILS20EPUV and the white calibration tile
are adjusted to be a set, and given the same number
in the factory. If you purchase two or more products,
make sure that you use the same numbered devices
in pairs.
The label of the white calibration tile
The label of ILS20EP/ILS20EPUV