Line; Log In To The Oat100R And Access The Main Menu - LG CodePlus OAT100R Installation & Setup Manual

Configuration Options via Command Line

Log In to the OAT100R and Access the Main Menu

Note: The OAT100R must be connected to an IP network for SSH client access. For direct
access to the OAT100R Service Port, use the FTDI TTL-USB cable (P/N TTL-232R-5V-AJ).
See also "Network and Communication Setup" on page 22 for further information.
If necessary, consult the system administrator to obtain the "admin" user password before
proceeding.
1. Establish communication with the OAT100R using an SSH client or via a direct connection
to the OAT100R Service Port.
Once communication is established, you should see a login prompt. (If the login prompt is
not automatically displayed, press Enter to refresh the screen.)
2. At the login as: prompt, type admin and press Enter.
3. At the password: prompt, type the admin user password and press Enter.
4. At the Command > prompt, either:
• Press Enter to display the OAT100R Main Menu (see example below).
• Type the desired command and press Enter.
The following sections describe each of the configuration commands.
Note: You can always press Enter at the Command > prompt to display the OAT100R Main
Menu.
Example: OAT100R Main Menu
---------
Main Menu
---------
info System information
monitor System monitor
map System program map
tuner Tuner Menu
setup Setup Menu
update Update Menu
reset System reset
exit End session
Command >
206-4218
39