View System Information; Monitor The System - LG CodePlus OAT100R Installation & Setup Manual

Configuration Options via Command Line (Cont.)

View System Information

1. Log in to the OAT100R as described on the previous page.
2. At the Command > prompt, type info and press Enter.
The System Information display identifies important information about the OAT100R,
including the unit serial number, software version, hardware ID (firmware version), Control
Port MAC and IP addresses, and output configuration, for example:
OAT100R
CodePlus Off Air Transcoder System
Copyright (c) 2010-2012 LG Electronics U.S.A, Inc.
Copyright (c) 2010-2012 Zenith Electronics LLC
Location:
SN:
Version
HW id:
Ctrl MAC:
Ctrl IP:
Program PIDs:
Output:
RF config:
RF channels:
Local time:
Note: If the system is configured for IP output, the Output field will show "IP" and RF fields will
not be present. Also, the Location field is only present if the site location has been specified
either in the GUI System Setup screen or in the command line interface Setup Menu.
It is recommended that you record this information for future reference. If you find it
necessary to call customer service or engineering support, please have this information
available.

Monitor the System

This option enables you to view static or dynamic system streaming data.
1. Log in to the OAT100R as described on the previous page.
2. At the Command > prompt, either:
• Type monitor and press Enter to display the current system data (see example on
following page).
• To monitor streaming data in real time, type monitor and the number of seconds before
the data refreshes. Then, press Enter. For example, to refresh the data every second,
type monitor 1 and press Enter.
When you are finished monitoring streaming data, press Enter to stop the system
monitor and return to the Command > prompt.
40
Chicago, IL
201-12301011
1.9
12-19
00:0C:63:3A:FF:EC
10.166.60.92
0x30 - 0x6f
RF
Mode 2, 256-QAM-B, RF: 6 MHz, 5.36 MSps
2 3 4 5
Wed Oct 17 14:42:02 CDT 2012
206-4218