Ip-900D/Ip-900Iid (Decoder) - Fujitsu IP-900E Hardware User's Manual

Chapter 2 Installation and Connection
2.3.2

IP-900D/IP-900IID (Decoder)

For audio and video decoding, there are one or two digital video, one analog video, one digital
audio and two analog audio terminals to connect and audio and video input device.
Digital and analog video output
Connect to SDI OUT using coaxial cable with BNC connector and output HD/SD-SDI signal.
SDI output can be supported for IP-900II D.
Connect to HDMI terminal using the HDMI cable. The signal is terminated in 50Ω.
Connect to ANALOG VIDEO OUT using coaxial cable with BNC connector and output
NTSC or PAL signal. The signal is terminated in 75Ω.
Digital audio output
The HDMI embedded audio is supported.
Analog audio output
Connect to ANALOG AUDIO OUT (L), (R) using the cable with RCA connector. The
impedance is 1KΩ unbalanced.
problem in terms of audio level and noise.
The figure below shows how to connect the digital and analog audio/video and the reference clock
cables.
For details about connectors and cables, see Section 4.2, "Cable and Connector Details."
NOTE:
For electrical specifications, see Appendix 2.3, "Function Specifications."
IP-900E/IP-900D series
Inputting a signal outside the rated value will cause a
100-240V
PWR ALM
RDY
FG
Figure Audio and video input device connections
100M
LINK
DEC
/ACT
MNT
Video & Audio Input Device
28
L R