Operation Management; Settings - Fujitsu IP-900E Hardware User's Manual

Chapter 3 Operation Instructions
3.3
3.3

3.3.1 Settings

On the PC Web browser, specify the IP address of IP-900E/IP-900D series (10.0.0.1) [example:
http://10.0.0.1/] to set up a connection to the http server of the IP-900E/IP-900D series.
When connect through LAN port, set the PC IP address and subnet mask as follows:
- IP address
(xxx is a number from 0 to 255, excluding 10.0.0.0, 10.0.0.1, and 10.255.255.255.)
［Example: 10.0.0.2］
- Subnet mask
The page shown below first appears (Initial page at power-on immediately after shipment from the
factory). The IP addresses and subnet masks set for the IP-900E/IP-900D series on the LAN, and
the gateway setting are displayed.
When you operate the IP-900E/IP-900D series with the default settings after
shipment from the factory, disconnect the IP-900E/IP-900D series from your
network. Connect it to the setting terminal via a Hub or directly. Set up the
IP-900E/IP-900D series to meet the requirements for your network and then
connect the IP-900E/IP-900D series to the network.
IP-900E/IP-900D series to your network with the default settings, an unexpected
problem may be caused with your network.
IP-900E/IP-900D series

Operation Management

: 10.xxx.xxx.xxx
: 255.0.0.0
If you connect the
38