Fujitsu IP-900E Hardware User's Manual page 70

Chapter 5 Troubleshooting
No. Class Status
12.
13.
14.
No image can
be output on the
15.
receiving side
(black screen).
16.
17.
18.
19.
Blue/gray
screen is output.
20.
21.
22.
23.
Image/audio
output is
24.
distorted.
The image
25.
output is
distorted.
(Analog input
26.
case)
IP-900E/IP-900D series
Description
Has the monitor on the receiving
side been powered on?
Has the device on the receiving
side been powered on?
Is the device on the receiving side
and monitor correctly connected?
Did the device on the receiving
side generate an alarm?
Does a color bar or gray screen
appear on the receiving side if
image input of the device is set to
non-input? (Since this operation
generates an alarm, obtaining the
system administrator's approval
before conducting this test.)
Is the RDY LED blinking?
Is the RDY LED turned on orange?
Is the ALM LED blinking?
Has the encoder started encoding?
Has the decoder started decoding?
Is the streaming setting correct?
Is the network normal?
Is packet loss occurring on the
decoder?
Is the setting of encoder PAL when
the camera or display is NTSC
type?
Is the setting of encoder NTSC
when the camera or display is PAL
type?
Check the power and operation of the
monitor.
Check the power and operation of the
device on the receiving side.
Check connections between the device on
the receiving side and the monitor.
If an alarm is generated, refer to the relevant
operating manuals on the receiving side, and
take appropriate corrective action.
If the blue screen is displayed, the receiving
side can be assumed to be operated
normally.
Verify that the correct image is input in the
device.
The hardware system is operating while the
RDY LED is blinking. Wait until the
LED remains on.
The device is started in the maintenance
mode.
Reboot the device.
ALM LED blinks when IP address
obtaining is on going or releasing. Check IP
address setting (For more information, refer
the Software User's Guide).
Set the encoder to start encoding.
Set the decoder to start decoding.
Make the correct streaming setting of this
device and the encoder by referring to the
Software User's Guide.
Refer to "Network" in this table.
If so, confirm the followings.
・Is system bit rate exceeding connected
network capacity?
・Are FEC/ARQ settings in this device and
the opposed device correct?
・Are the network device and LAN port
settings (AUTO, Full/Half-duplex, etc) the
same?
Change encoder setting from PAL to NTSC.
(Check decoder setting too.)
Change encoder setting from NTSC to PAL.
(Check decoder setting too.)
56
Recommended action