Table of Contents
Advertisement
To configure Media-Store mode:
2
1
1.
Press MENU.
2.
Press the SYSTEM Wipe Pattern button.
3.
Press NEXT until Media is displayed.
4.
Use the Media knob to select the Media-Store
mode. You can choose from the following:
• Tall — Two channels of Media-Store are
available. Each channel may contain an
image or channel 1 may contain an image and
an associated alpha-channel is contained in
channel 2.
• Dual — Four channels of Media-Store are
available. Two channels are reserved for
images and two channels are reserved for
associated alpha-channels.
Table 5 Dual Mode Media-Store Channels
Image Channel
1
2
5.
Press the Media knob to save your selection.
6.
Press the Confrm knob to commit the change.
Press the Cancel knob to cancel the change.
For More Information on...
• Media-Store, refer to the chapter "Media-Store".
Transition Area Behavior
You can set the behavior of the transition area to suit
your needs.
To configure the Next Transition Area behavior:
1
2
20
4
3
Alpha Channel
3
4
5 4,6
7
3
1.
Press MENU.
2.
Press the PERS Wipe Pattern button.
3.
Press NEXT until Trans Area is displayed.
4.
Press the Trans Area knob to display the
Transition Area menu.
5.
Use the Trans knob to set the behavior of the
Next Transition area after a transition is
performed. You can choose from the following:
• Reset — The Next Transition area is reset to
a background dissolve transition
• NotRst — The Next Transition area is not
reset.
6.
Use the Auto 2 knob to set the behaviour when a
a transition is paused by pressing AUTO TRANS
during a transition. You can choose from the
following:
• HltFwd — The transition pauses. When you
resume the transition, it completes as
originally set.
• HltRev — The transition pauses. When you
resume the transition, the transition proceeds
in reverse and the switcher returns to the
on-air state it was in before the transition was
started.
• Rev — The transition immediately reverses
and the switcher returns to the on-air state it
was in before the transition was started.
7.
Use the ARKey knob to set whether a key
remains or is removed from the Next Transition
area after a dedicated key transition is
performed. You can choose from the following:
• Off — The key is removed from the Next
Transition area after a dedicated key transition
is performed.
• On — The key remains active in the Next
Transition area after a dedicated key transition
is performed.
NEXT button Secondary Function
You can configure a secondary function of the NEXT
button allowing it to be used, in conjunction with the
Wipe Pattern buttons, to trigger GPI outputs.
To configure the NEXT button secondary
function:
1
2
3
5
6
4
Advertisement
Table of Contents
