Saving And Reverting Attributes - JVC KM-H2500 Manual

Modifying Animation Playback
You can set an animation to playback automatically
as well as control playback speed and direction.
To modify animation playback:
3
2
1. Press and hold SHIFT on any bus. If you use the
Program bus or on-air Key bus, you will affect
on-air images.
2. Press MEDIA 1 or MEDIA 2 to select a
Media-Store channel with a loaded animation.
3. Press NEXT until Attrib is displayed.
4. Set the looping behavior as follows:
• Use the Attrib knob to select Looping.
• Use the Value knob to set the looping
behavior. You can choose from the following:
› yes — The animation plays in a continuous
loop until manually stopped.
› no — The animation plays once.
5. Set the playback direction as follows:
• Use the Attrib knob to select Reverse.
• Use the Value knob to set the reverse
playback behavior. You can choose from the
following:
› yes — The animation plays backwards.
› no — The animation plays forwards.
6. Set the auto playback behavior as follows:
• Use the Attrib knob to select AutoPly.
• Use the Value knob to set the auto playback
behavior. You can choose from the following:
› yes — The animation starts playing
automatically when it is taken on-air.
› no — Animation playback must be started
manually.
7. Set the playback speed as follows:
• Use the Attrib knob to select Speed.
• Use the Value knob to set the playback
speed. You can set a playback speed from:
› 0.1x – 1.0x in 0.1x increments.
› 1x – 10x in 1x increments.
4 5
1

Saving and Reverting Attributes

You can save attributes for an image so they are
automatically recalled the next time that image is
loaded from a USB drive or internal memory.
Image attributes that have been changed since they
were last saved are marked with a '*'.
To save attributes for an image:
1. Modify the attributes for an image as necessary
2. Use the Func knob to save the attributes for that
image. You can choose from the following:
• Save — Saves the currently displayed
attribute. Other saved attributes are not
affected.
• SavAll — Saves all attributes.
To revert to saved attribute values:
3
2
1. Press and hold SHIFT on any bus. If you use the
Program bus or on-air Key bus, you will affect
on-air images.
2. Press MEDIA 1 or MEDIA 2 to select the
Media-Store channel to load the image into.
3. Press NEXT until Attrib is displayed.
4. Use the Func knob to save the attributes for that
image. You can choose from the following:
• Revert — Reverts the currently displayed
attribute to the previously saved value. Other
attributes are not affected.
• RevAll — Reverts all attributes to previously
saved values.
2
4
1
55