To Unsave A Measurement Setup - HP 53131A Operating Manual

Chapter 2 Operating Your Universal Counter
Using the Save and Recall Menus

To Unsave a Measurement Setup

1 To unsave the measurement setup you've saved in the previous procedure,
press Save & Print key until UNSAVE: NO is displayed.
2 Press the appropriate arrow keys to select UNSAVE: 1 , then press Enter
key.
The measurement setup that was saved in register 1 ( RECALL: 1 )
is deleted or unsaved.
ADDITIONAL INFORMATION ABOUT UNSAVE
If the UNSAVE: display DOES NOT show up after the SAVE: display, then
no setups have been saved; all registers are empty.
If UNSAVE: display is present in the Save & Print key menu, then at
least one setup has been saved. (To determine how many setups are saved,
continuously press the
the number of registers that are present.) Perform step 2, below, to delete
a measurement setup.
1 Suppose there are two registers (1 and 2) that have setups saved in them.
To remove these setups, perform the following:
a. At the UNSAVE:
UNSAVE: 2 is displayed, indicating that register 1 has been cleared.
To check if the clearing was done, press the
should not exist.
b. At the UNSAVE:
All registers are cleared when the UNSAVE menu item is NOT present
in the Save & Print key menu.
2 Now, suppose in the previous step (2) you wanted to leave register 1 alone,
but you want to delete register 2. Perform the following steps:
a. At the UNSAVE:
UNSAVE: 2 is displayed.
b. Press Enter key to delete register 2.
Operating Guide
key while UNSAVE:
1 display, press Enter key.
2 display, press Enter key.
1 display, press key.
n is displayed and count
key; the " 1 " display
2-55