Panasonic EASA-PHONE KX-T61610 Installation Manual page 132

.. .;.;.pR&&M.;.,. ,. ..!~ .
,,.
._' -:.
: 1,
Extension does not operate.
When using the
speakerphone mode,
nothing is heard.
The unit does not rin.g.
During a power interruptior
extensions 11 through 26 do
not operate.
The Power failure switch of
Set the Power failure switch to OFF.
the KX-T61630 or
KX-T30830 is set to ON.
The HANDSETI
When the headset is not used, set the HANDSETI
HEADSETselector of the
HEADSETselector to the "HANDSET" positior..
KX-T61630 or KX-T30830
is set to the "HEADSET"
position.
- I
1,
I
Ringer Volume Selector is
set to "OFF".
Set to "HIGH" or "LOW".
e The Power failure switch
of the KX-T61630 or
KX-T30830 is set to OFF.
l
The dialing mode (tone or
pulse} is improper.
l
KX-T61620, KX-T616.50,
KX-T30820 or KX-
T308.50 is connected.
OSet the power failure switch
10
ON.
l Ser rhe TonelPulse switch to the other position.
l
Disconnect KX- T61620, KX-T61650,
KX-T30820 or KX--30850 and connect the
KX-T61630, KX-T30830 or a standard tele-
phone.
If
the system is not operating properly, use the Reset
Button.
@Before using the Reset Button, try the system
feature again which does not work several times
IO
confirm there definitely is a problem.
*Pressing the Reset button will cause the followings.
1. Camp-on to be cleared.
2. Last number redial to be cleared.
3. Saved number redial to be cleared.
4. Calls on ho/d are terminated.
5. Calls on exclusive hold are terminated.
6. Calls in progress are terminated.
Data that is stored in memory other than above
mentioned will not be cleared by use of the Reset
Button.
Note
lf the system does not operate properly, push the
Resel Button.
If
there still is no difference, switch the power
off
and on again after 5 minutes. If the system still does
not work, switch the power off.
The following extensions will be directly connected
to each of the central ofice lines (C. 0.).
Extension ll...C.O.I
Extension 1.Z : . C. 0.2
Extension 13...C.O.3
Extension 14.. .C. 0.4
Extension lS...C.O.5
Extension 16...C.O.6
If the KX-Al6 is connected to the system, switch off
the power of the KX-A16.