Co Connection Assignment - Panasonic EASA-PHONE KX-T61610 Installation Manual

r
:_.~.*~--~.~~ Ltrrtil the desired CO number appears
: ;_ _____
.__ ____
[03] [NEXT] [w] [SELECT] [MEYORY] [END]
or
T I
[03] [NEXT] [Al [SELECT] [MEMORY] [END]
A=*: to &sign the same on all 6 CO's
1:
0nCOI
Description
You can program which outside line is con?,
netted and which one is not connected. .
When an extemion automatically selects ali idle
outside line, the extetlsioll can be connected to it
quickly.
Programming
1.
Dial (03).
"CO CONNECTION" will be displayed.
2. Press the NEXT button.
"ENTER CO NO" will be displayed.
3.
Press the NEXT button.
"CO 1: CONNECT" will be displayed and
"CONNECT" will blink.
4. Press the SELECT button, to alternate be-
tween CONNECT and NO CONNECT to
select the desired mode.
5. Press the MEMORY button.
The LCD -will stop blinking.
6. Repeat steps 3 to 5, to program the dialing
mode on the other CO lines.
7.
To return to the initial program mode, press
the END button.
Conditions
::
l
When you start the programming from step 1,
yowl may
dial the desired CO number instead
of the NEXT button at step 3.
l
The PREV btctton allows you to see the entr)
status iti the previous CO cotinectio~i assigri-
ment.
Example:
CO 1 and 2 . . . . . , . . . . . . . . . CONNECT
CO 3
. . . . . . . . . . . . . . . . . . NOCONNECT
1. [03] [NEXT] [(NEXT)
or
(l)] [MEMORY]
2.
[NEXT] [MEMORY]
3.
[NEXT] [SELECT] [MEMORY] [END]
Programming Table
See page
6-14.
3-10