Toshiba TOSVERT VF-S15 series Function Manual page 26

Address Signal
RWwn+10 Instruction code 2
RWwn+11 Write data 2
RWwn+12 Instruction code 3
RWwn+13 Write data 3
RWwn+14 Instruction code 4
RWwn+15 Write data 4
RWwn+16 Instruction code 5
RWwn+17 Write data 5
RWwn+18 Instruction code 6
RWwn+19 Write data 6
RWwn+1A
to Reserved
RWwn+1F
"n" is depend on the station number.
Set the command code for actions such as operation mode switching,
parameter read, write, error reference, error clear, etc. The command will
be executed by turning (RynF) on after the register setting is completed.
When the command execution is completed, (RXnF) turns on.
Set data specified by the above-mentioned command code 2
(if necessary). If no data needs to be written, the value shall be zero.
(RynF) is turned on after setting the above-mentioned command code
and this register.
It is the same as instruction code 1 and 2.
Set data specified by the above-mentioned command code 3
(if necessary). If no data needs to be written, the value shall be zero.
(RynF) is turned on after setting the above-mentioned command code
and this register.
It is the same as instruction code 1 and 2.
Set data specified by the above-mentioned command code 4
(if necessary). If no data needs to be written, the value shall be zero.
(RynF) is turned on after setting the above-mentioned command code
and this register.
It is the same as instruction code 1 and 2.
Set data specified by the above-mentioned command code 5
(if necessary). If no data needs to be written, the value shall be zero.
(RynF) is turned on after setting the above-mentioned command code
and this register.
It is the same as instruction code 1 and 2.
Set data specified by the above-mentioned command code 6
(if necessary). If no data needs to be written, the value shall be zero.
(RynF) is turned on after setting the above-mentioned command code
and this register.
Reserved
- 25 -
Description
E658130