Table of Contents
Advertisement
Channel Search
Normally, this function is only used when first installing and setting up the digital receiver as de-
scribed earlier in this manual. You will need to use this function again if you re-install the receiver
in another location or wish to search for new channels that have been added since setup was
conducted. To use this function, follow the instructions below.
To re-install the digital receiver, press the MENU
button, select Option 5 "Getting started," and then
select Option 4 "Store channels."
Since the digital receiver is already setup, a warning message will
be displayed notifying you that existing channel information will be
lost by the setup process. If you do not want to lose this informa-
tion, press the RED button to return to the Main menu. No changes
will be made.
NOTE:
• During installation the number of channels that have been
found and the search completion percentage at that point in
time will be displayed on the screen. The message "Your
ONdigital box is searching for all available channels–this could
take a few minutes, please wait" will also be displayed.
• The receiver will continue to tune until it has found all chan-
nels or the RED button is pressed. When all channels have been
found the menu will disappear and the channel list will be dis-
played.
Adding Channels
This option is used to look for new channels that have been started since the digital receiver was
installed. It will not change the channels already stored, only add those that have started broad-
casting since it was originally installed.
To search for new channels, press the MENU button, select Option 5 "Getting started," and then
select Option 3 "Add channel."
ADVANCED SETTINGS
<BRB1056>
49
Advertisement
Table of Contents
