NEC Express5800 Series User Manual page 120

4-22 System Configuration
Option
BMC Firmware Revision
SDR Revision
PIA Revision
Module#0 BMC MAC Address*
Module#1 BMC MAC Address*
* MAC address information is shown only when the N8815-001/001A ft Remote Management Card
is installed.
Console Redirection
Select "Console Redirection" on the System Hardware menu and press Enter to display the
following screen.
See the table below for setup options on the screen.
Option
BIOS Redirection
[Disabled]
Port
Enabled
Baud Rate* 9600
[19.2K]
38.4K
57.6K
115.2K
Parameter Description
Displays the BMC information.
Displays the revision of SDR (sensor
device information).
Displays the PIA (plat form information)
revision.
Displays the BMC MAC address of
CPU/IO module#0.
Displays the BMC MAC address of
CPU/IO module#1.
Parameter
Enable or disable Console Redirection. By enabling
this option, you can remotely control behavior during
POST.
Select a port rate used for the interface with a
hardware console to be connected.
[ ]: Factory-set
Description