NEC Express5800 Series User Manual page 133

Advanced Configuration
When you select "Advanced Configuration" and press the Enter key, the display changes as shown
below:
The following table provides information on options and their functions.
Option
Reset SCSI Bus at IC
Initialization
Display <Ctrl><Alt> Message
During BIOS Initialization
Extended Int 13 Transfer for
DOS Drivers > 1 Gbyte
Post Display Mode
SCSI Controller Int 13
Support
Domain Validation
Support Removable Disks
under Int 13 as Fixed Disks
BIOS Support for Bootable
CD-ROM
Parameter
Set "Enabled."
[Enabled]
Disabled
[Enabled] Set "Enabled."
Disabled
[Enabled] Set "Enabled."
Disabled
[Verbose] Do not change the settings unless it is
Silent necessary.
Diagnostic
[Enabled] Select whether or not to enable SCSI BIOS.
Disabled: NOT Scan Select "Enabled" except
Disabled: scan bus
[Enabled] Set "Enabled."
Disabled
Boot Only Options controlled by removable media are
All Disks supported by AIC-79xx BIOS.
[Disabled]
[Enabled] Set "Enabled."
Disabled
System Configuration 4-35
Description
when starting up the OS from a hard
disk drive other than those connected to
the SCSI controller (it is OK if no hard
disk drive is connected to controller
other than SCSI controller).
when reserving a space in the extended
ROM space. In this case, you can
disable the BIOS of a SCSI controller to
which no hard disk drive is connected.
[ ]: Factory-set