NEC Express5800 Series User Manual page 152

4-54 System Configuration
(1) Displays the BMC host name or IP address
(2) Displays the LCD of the server.
(3) The power lamp of the server telling you of the power status
(4) The same as pressing the POWER switch of the server, but pressing it for 4 or more seconds
(the forced power off) is not supported.
(5) Performs memory dump on the server (the same as pressing the DUMP switch of the server).
(6) Makes the Unit ID lamp of the server blink
(7) Starts up the remote KVM console.
(8) Starts up the BMC configuration.
(9) Stats up the firmware update.
(10) A user name is displayed here.
(11) Displays the connectivity with BMC.
(12) Displays communication security status
(13) Displays network access status
(14) The status lamp of the server telling you of the server status.
(15) Opens the window showing system event logs (SEL).
(16) Opens the window showing the sensor device information (SDR).
(17) Opens the window showing the information on parts to be replaced for maintenance (FRU).
(18) Displays the slot position information (module #0 or module #1)
(19) Displays the slot status (primary or secondary).
(20) Hides the control panel