Table of Contents
Advertisement
SETTING THE CLOCK
(Main unit operation)
MEMORY/SET
ON/
STAND-BY
CLOCK
TUNING/
TIME
(
)
2
3
4
0:00
AM 0:00
5
6
7
8
9
In this example, the clock is set for the 24-hour (0:00) system.
1
2
3
4
5
6
7
8
AM 12:00
9
To see the time display:
Press the CLOCK button.
Note:
To change the clock time:
To change the time display mode:
E-11
Press the ON/STAND-BY button to enter the stand-by mode.
Press the CLOCK button.
Within 5 seconds, press the MEMORY/SET button.
Press the TUNING/TIME (
display mode.
"0:00"
The 24-hour display will appear.
(0:00 - 23:59)
"AM 0:00"
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed
or it has been reset (see page 23).
Press the MEMORY/SET button.
Press the TUNING/TIME (
Press the TUNING/TIME (
the time by 1 hour. Hold it down to advance continuously.
When the 12-hour display is selected, "AM" will change auto-
matically to "PM".
Press the MEMORY/SET button.
Press the TUNING/TIME (
minutes.
Press the TUNING/TIME (
the time by 1 minute. Hold it down to change the time in 5
minute intervals.
The hour setting will not advance even if minutes advance from
"59" to "00".
Press the MEMORY/SET button.
The clock starts operating from "0" second.
(Seconds are not displayed.)
And then the clock display will disappear after a few seconds.
The time display will appear for about 5 seconds.
The clock display will flash on and off at the push of the CLOCK
button when the AC power supply is restored after a power
failure occurs or after the AC power lead is disconnected.
If this happens, follow the procedure below to change the clock
time.
Press the CLOCK button.
Within 5 seconds, press the MEMORY/SET button.
Perform steps 6 - 9 above.
Perform steps 1 - 2 in the section "RESETTING THE MICRO-
COMPUTER", on page 23.
Perform steps 1 - 9 above.
X
W
or
) button to select the time
X
W
or
) button to adjust the hour.
X
W
or
) button once to advance
X
W
o r
) button to adjust the
X
W
or
) button once to advance
Advertisement
Table of Contents
