Table of Contents
Advertisement
RADIO OPERATION
(Main unit operation)
1
2,3,5,6
4
Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button.
3
Press the TUNER (BAND) button to select the desired fre-
quency band. (FM ST, FM or AM)
4
Press the TUNING/TIME (
desired station.
Manual tuning:
Press the TUNING/TIME (
required to adjust the frequency shown on the display to the
frequency of the desired station.
Auto tuning:
When the TUNING/TIME (
than 0.5 seconds, scanning will start automatically and the tuner
will stop at the first receivable broadcast station.
Notes:
When radio interference occurs during auto scan tuning, auto
scan tuning may stop automatically at that point.
If a weak station signal is found during auto scan tuning, the
station will be skipped.
To stop the auto tuning, press the TUNING/TIME (
button again.
5
To receive an FM stereo transmission, press the TUNER
(BAND) button so that the "ST" indicator on the display lights
up.
j
"
" will appear when an FM broadcast is in stereo.
6
If the FM reception is weak, press the TUNER (BAND) button
so that the "ST" indicator goes out.
Although the reception changes to monaural, the sound
becomes clearer.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Note:
The last station tuned in will be recalled, even after changing
the tuning band or the function, or after switching the unit to
the stand-by mode.
E-16
X
W
or
) button to tune into the
X
W
or
) button as many times as
X
W
or
) button is pressed for more
X
W
or
)
Advertisement
Table of Contents
