Using External Units - Sharp CD-80W Operation Manual

(Continued)
(Main unit operation)
TIMER/
SLEEP
TUNING/
TIME
( )
2
3

USING EXTERNAL UNITS

To the line output socket
MEMORY/
SET
RCA
lead
Sleep operation
The radio, compact disc and cassette deck can all be turned off
automatically.
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until "SLEEP" is
displayed.
To change the sleep time:
W
Whilst the sleep time is displayed, press the TUNING/TIME (
or ) button to adjust the time.
(Maximum: 3 hours - Minimum: 1 minute)
The amount of sleep time can also be changed during the sleep
operation.
3 hours - 5 minutes
5 minutes - 1 minute
3
Press the MEMORY/SET button.
4
The unit will enter the stand-by mode automatically after the
preset sleep time has elapsed.
Note:
Once the sleep time is set, it will remain the same duration
until the setting is changed.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button.
To cancel the sleep operation:
Press the ON/STAND-BY button to enter the stand-by mode.
Video/Auxiliary (Audio signal) input
To listen to or record signals from external sources
through this unit:
1
Use a separately available RCA lead to connect the desired
external unit to the VIDEO/AUX sockets.
(red right channel, white
When using video equipment (Laser Disc player or VCR), be
sure to connect the audio output to this unit and the video
output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the VIDEO/AUX button.
4
Operate the external unit.
5
To record the sound from the external unit, perform steps 2
- 5 of the "Recording from the built-in radio" section on page
20.
Note:
To prevent hum interference, do not place this unit near a
television receiver.
E-22
5-minute intervals
1-minute intervals
left channel)
X