Network --Troubleshoot [--Links] [--Gateway] [--Ntp] [--Dns] [--Active_Domain] [--Nis] [--Clients]; Port_Mapper] [--Network_Config] [--Show_Active <Nfs | Cifs | Ost>] - Dell PowerVault Storage Area Network Reference Manual

network --troubleshoot [--links] [--gateway] [--ntp] [--dns] [--active_domain] [--nis] [--
clients] [--port_mapper] [--network_config] [--show_active <nfs | cifs | ost>]
Isolates a variety of networking issues that you might encounter while running a DR Series system. When you can
isolate a problem or issue to a specific cause, you can better understand and resolve it. The DR Series system CLI
network --troubleshoot command and its options allow you to perform basic troubleshooting checks on the state of a DR
Series system.
Description
NOTE: When entering the network --troubleshoot command string, the DR Series system checks and displays the
current state for all of the --troubleshoot options. To limit the type of network troubleshooting check you want to
display, define the command string to a specified check (or checks). For example, using network --troubleshoot --
gateway, displays the status of the gateway for a DR Series system (for details, see
gateway]).
Syntax
network --troubleshoot
Result
*** Checking link status for each interface
bond0 : Link detected: yes
eth0 : Link detected: yes
eth1 : Link detected: yes
eth2 : Link detected: yes
eth3 : Link detected: yes
lo : Link detected: yes
*** Getting local IP addresses
bond0 addr:10.25.20.23 Mask:255.255.245.0
*** Getting bond information
Ethernet Channel Bonding Driver: v3.4.0 (October 7, 2008)
Bonding Mode: transmit load balancing
Primary Slave: None
Currently Active Slave: eth0
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: eth0
MII Status: up
Link Failure Count: 0
Permanent HW addr: 00:50:56:93:59:7a
Slave Interface: eth1
MII Status: up
Link Failure Count: 0
Permanent HW addr: 00:50:56:93:59:7b
Slave Interface: eth2
MII Status: up
Link Failure Count: 0
Permanent HW addr: 00:50:56:93:59:7c
40
network --troubleshoot [--