4.3.1.13 Sector Number Register; 4.3.1.14 Atapi Status Register; Io And Cod; Bit Definitions Of Atapi Status Register - Fujitsu MCE3064AP Product Manual

IO CoD
0 1 Packet command transfer
1 0 Data or parameter transfer (from the ODD to the host)
0 0 Data or parameter transfer (from the host to the ODD)
1 1 The completion status in the Status register is effective.

4.3.1.13 Sector Number register

This register is not used. The ODD ignores all specified values.

4.3.1.14 ATAPI Status register

This register indicates the status of the ODD. It is updated to reflect the current ODD status and
the progress of the current command. When the BSY bit is 0, other bits of the register are effective
and some other command block registers may be set with significant information. When the BSY
bit is 1, the other bits of this register and all other command block registers are ineffective.
While the ODD is in sleep mode, the ATAPI Status register and all other command block registers
are ineffective.
If the host reads this register during interrupt pending, the interrupt is cleared.
7 6
BSY DRDY
!
BSY (Busy) is set during command block register control. When BSY is 1, the ODD ignores
all command block registers other than the Device Reset command.
The ODD updates the DRQ and CHECK values only when BSY is 1. After the final block of
the PIO data-in command is transferred, the BSY bit setting is canceled and the DRQ bit is
cleared.
When BSY is 0, the ODD may update the SERVICE bit of the ATAPI Status register and the
Data register. The ODD does not update all other command block registers and the ATAPI
Status register bits.
The ODD sets BSY:
a) After RESET- is negated or within 400 ns of setting the SRST bit of the Device
Control Register
4 - 10
Table 4.13 IO and Cod
Table 4.14 Bit definitions of ATAPI Status register
5 4
Reserved SERVICE
(0b)
C156-E142-02EN
Meaning
3 2
DRQ CORR Reserved
(0b) (0b)
1 0
CHECK Read