Removing The Display Bezel - Dell 1525 - Inspiron - Pentium Dual Core 1.86 GHz Service Manual

NOTE: Ensure that the display cable, camera cable, and antenna cables are properly routed and secured beneath the plastic tabs.
6. Connect the display cable to the display cable connector on the system board.
7. Connect the camera cables to the camera cable connector on the system board.
8. Replace the keyboard (see
9. Replace the center control cover (see
10. Close the display and turn the computer over.
11. Replace and tighten the two screws securing the display assembly from the bottom of the computer.
12. Connect the antennae cables to the Mini-Cards (see
13. Replace the back cover and tighten the eight captive screws on the cover.
Display Bezel

Removing the Display Bezel

CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
1. Follow the instructions in Before You
2. Remove the center control cover (see
3. Remove the keyboard (see
4. Remove the display assembly (see
5. Remove the six rubber display bumpers from around the display bezel.
6. Remove the captive screw and five shoulder screws from around the display bezel.
1 captive screw 2 rubber display bumpers (6)
3 shoulder screws (5) 4 display panel
5 display bezel
NOTICE: Removal of the bezel from the display back cover requires extreme care to avoid damage to the bezel and the display panel.
7. Starting from the bottom corner of the display panel, use your fingers to pry the bezel from the top cover, then lift the inside edges to separate the
Replacing the Keyboard).
Replacing the Center Control
Wireless Mini-
Begin.
Removing the Center Control
Removing the Keyboard).
Removing the Display Assembly).
Cover).
Cards).
Cover).