Removing The Palm Rest - Dell 1525 - Inspiron - Pentium Dual Core 1.86 GHz Service Manual

Back to Contents Page
Palm Rest
Dell™ Inspiron™ 1525/1526 Service Manual

Removing the Palm Rest

CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
1. Follow the instructions in Before You
2. Remove the center control cover (see
3. Remove the keyboard (see
4. Remove the internal card with Bluetooth wireless technology, if installed (see
NOTE: It is not necessary to remove the Bluetooth cable connector from the system board connector.
5. Disconnect the button board cable from the system board.
6. Disconnect the speaker cable from the system board.
7. Remove the display assembly (see
8. Remove the nine screws from the bottom of the computer.
NOTE: The screw locations may vary slightly from the image shown below.
9. Turn the computer over and remove the two screws securing the top of the palm rest.
10. Disconnect the touch pad connector and the device status lights LED connector from the system board.
NOTICE: Do not use force to separate the palm rest from the computer. If you encounter resistance, gently flex or apply pressure to the palm rest, or
move along the edge, working away from the area of resistance, until the palm rest is free.
Begin.
Removing the Center Control
Removing the Keyboard).
Removing the Display Assembly).
Cover).
Removing the Internal Card With Bluetooth® Wireless Technology).