Configuration - Motorola 110502USM001 - Vanguard 60 Router User Manual

Configuration

Configuration
Introduction
Parameter
Descriptions
Parameters
Applicable For All
Applications
3-2
The example configurations provided in this section highlights the important
parameters that should be configured. For a step by step procedure on how to
configure the Vanguard Router, refer to the Vanguard Basic Configuration Manual
(Part Number T0113).
"Configure LAN Connections" section on page 3-9 provides detailed parameter
descriptions. For other parameters descriptions and more detailed configuration
examples you may have to refer to the feature or protocol manual.
This section list the table records and parameters that you should configure for
Vanguard Router operation regardless of network layer operation. Later sections will
highlight additional parameters you will need to configure for specific operation or
applications.
Step
1 Configure the Node Record.
2 Configure the WAN Port. The WAN
Port may be one of the following:
• Frame Relay
• X.25
• MX.25
• ISDN
• PPP
• XDLC
Note
Depending on the WAN Port you
select, you may need to configure
other WAN records or parameters.
Refer to the specific feature or
protocol manual for more information
on configuring parameters for the
WAN port.
3 Configure the LAN Port:
• Ethernet
• Token Ring
4 Enable the Router Interface State(s)
5 Configure the LAN Connection Table
(LCON).
6 Configure the Mnemonic Table
7 Configure the Route Selection Table
Configure Menu
Configure -> Node
Configure -> Port
Configure -> Port
Configure -> Configure Router ->
Configure Router Interface State
Configure -> Configure LAN
Connections
Configure -> Configure Network
Services -> Mnemonic Table
Configure -> Configure Network
Services -> Route Selection Table
Configuring a Vanguard Router