Motorola 110502USM001 - Vanguard 60 Router User Manual page 69

Configuring a Vanguard Router
T0100-01, Revision B
Next Hop IP Address
Range: A valid IP address in dotted decimal notation
Default: 0.0.0.0
Description: Specifies the IP address of the Router Interface on the other end of
this LAN Connection, which is the next hop on the path to the
final destination. This LAN Connection is used if it is the optimum
route to reach the destination IP address. Note that the Network
and Host portion of the IP address is needed.
A setting of 0.0.0.0 for a LAN connection using RFC 1294
encapsulation and mapped to a Frame Relay BYPASS station or
Annex G circuit will result in an InvARP Request being sent.
For all other LAN connections a value of 0.0.0.0 causes this
parameter to be ignored.
Guidelines: Appears only if the LAN Connection type is configured as
GROUP.
Next Hop IPX Node Number
Range: 1 to 12 hexadecimal digits
Default: 0
Description: Specifies the IPX node number of the Router on the other end of
this LAN Connection, which is the next hop on the path to the
final destination. This LAN Connection is used if this is the
optimum route to reach the destination IP address.
A setting of 0 causes this parameter to be ignored.
Guidelines: Appears only if the LAN Connection Type is configured as
GROUP and the Encapsulation Type is CODEX or RFC1294.
Configure LAN Connections
Release 5.4
3-19