Enabling or Disabling Send after Scan Temporarily
If the Send After Scan Mode
Default Setting is set to "OFF",
this feature allows you enable
the Send After Scan mode for
a single transmission. Once
that transmission is complete,
the default status is regained.
If you enable Send after Scan,
you will be given the opportuni-
ty to select "SEND SCANNED
PAGES" or "CANCEL SEND-
ING."
Select "SEND SCANNED
PAGES" if you want the pages
scanned to memory (prior to
the Memory Full) to be trans-
mitted.
Select "CANCEL SENDING" if
you want to cancel that trans-
mission and try again later
when more memory is avail-
able or use a Direct TX opera-
tion.
NOTES:
• To change the default set-
ting of this function, refer
to page 148. The status
selection in this operation
will take precedence over
the default setting.
166
1
Load the Document
Load the document face down
in the Document Support (see
page 82).
Adjust the resolution and con-
trast if desired (see pages 83
and 84).
JAN-31 09:43 AM 100%
AUTO RECEIVE
2
Display the SEND
AFTER SCAN Menu
Press:
MENU
+
+
+
+
SEND AFTER SCAN
1.ON
2.OFF
3
Select the Send
After Scan Option
Select the desired Send After
Scan Option.
To enable Send After Scan,
press:
UPON MEMORY FULL
2.SEND SCANNED PAGES
1.CANCEL SENDING
Go to Step 4.
To disable Send After Scan,
press:
The following is displayed for 2
seconds.
COMPLETED
Go to Step 5.
4
Select the Memory
Full Option
Select the desired Memory Full
Option.
To cancel the pages that have
been scanned, press:
To send the pages that have
been scanned, press:
The following screen is dis-
played. You may dial the re-
mote facsimile for your com-
munication job. The display will
return to the Standby Mode in
about 60 seconds if no keys
are pressed.
JAN-31 09:43 AM 100%
ENTER TEL NUMBER