Quick Start; Terminal Id; Transmitting; Receiving - Toshiba ESTUDIO170F Operation Manual

- QUICK START

This section provides several
quick start programming steps
to prepare your new facsimile
for immediate use.
These procedures are a simple
version of the detailed proce-
dures listed in the manual.
Next to each procedure head-
ing is a convenient page num-
ber reference for the detailed
procedure. Should you have
any difficulty with these simple
procedures, refer to the pages
listed for more information.
It is highly recommended that
you take the time to read
through this manual to get the
most from your new TOSHIBA
facsimile.
34

Terminal ID

1
Setting the Terminal ID (Page 42)
MENU
Press: , ,
NAME (40MAX)
[ ]
Enter your user ID (company
name) using the Dial Keypad,
press:
INT. CODE ?
1.YES
2.NO
If you communicate internation-
ally, select:
Otherwise, select:
FAX NUMBER (20MAX)
[ ]
Enter your facsimile's tele-
phone number, press:
COMPLETED
Displayed for 2 seconds
INITIAL SETUP
3.TERMINAL ID
Press:
STOP

Transmitting

2
Sending a Facsimile
(Page 93)
Load your document face down
into the Document Support.
JAN-31 09:43 AM 100%
AUTO RECEIVE
Dial the remote facsimile using
the Dial Keypad located on the
Operation Panel. Remember to
include any access numbers
REDIAL
such as 9 or press the af-
PAUSE
ter the access number if you
normally have to wait for a dial
tone.
After the remote facsimile
number has been entered into
the keypad, press the green
START key.
START

Receiving

3
Receiving a
Facsimile (Page 102)
Your TOSHIBA facsimile has
been preset from the factory to
receive facsimile messages.
No special setup is required to
receive facsimile messages.