Hitachi SelecSet 900 Series User Manual page 99

B K G
ASIC EY ROUP
Procedure
3-12
F
EATURES
To use group hold, follow these steps:
1
After answering a call, press a group hold key to hold
the call.
2
You see this display:
3
Announce (using the <ANNO> key) to the party for
whom the call is holding that the call is being held, on
line 1, for example.
4 Either you or another key group member should press
<SPKR> or lift your handset.
5
Press the <GH> (group hold) key.
6
You or the other key group member is connected to
the holding party.
If you do not have an autodial key programmed for
group hold, contact your system administrator, who
can assign it to your phone. See
Feature Keys"
programming an autodial key for a feature.
S
on page 1-24 for instructions on
HCXTD850, Rev. A02, September 2001
S 900 U
ELEC ET SER
"Programming
G
UIDE