Advertisement
Pmacing the Dishwasher/Securing
the Dishwasher
PLACmNG THE DISHWASHER
1 Straighten and position the hot water supply line and
the electrical supply cable as shown in Figure 19 so
that they wiii align with their channels under the
dishwasher base.
2 Position the dishwasherclose
enough to the enclosure
so that you can run the dishwasher drain hose to the
under sink drain connection. Make certain that the hot
water supply line and the electrical supply cable are in
their channels under the dishwasher base, as shown in
Figure 20,
3 Slide the dishwsher into the opening making sure that
the hot water supply line and the electrical supply
cable stay in their proper channels.
4 Make sure the dishwasher is level. Adjust the rear
leveler by turning the center screw at the front of the
dishwasher, as shown in Figure 21a. Turning the screw
clockwise raises the rear of the dishwasher. Adjust the
front levelers by turning them with a screwdriver, as
shown in Figure 21b. Turning the levelers to the right
raises the dishwasher, if additional height is needed,
shims may be added under the leveler feet.
Channels
Figure 20
SECURING
THE DISHWASHER
1 Drive the mounting screws through the hobs in the
mounting brackets as shown in Figure 22 for Top or
Side Mount.
Figure 21
/
Top Mount
10
Advertisement
